Product Information: Information on this page is for quotation purposes only; not for construction unless certified. Data subject to change without notice. All dimensions are in inches unless noted.

• 12 gauge mild steel bolted construction to operate up to +/- 17″ [wg]
• Lifting lugs on clean air plenum
• 4″ or 6″ SCH 40 pipe header for compressed air reservoir
• Internal compressed air hard piping
• 3/4″ or 1″ diaphragm valves
• Blower outlet and header orientation per job
• NEMA 4 sequence timer enclosure
• 3/4″ NPT thermocouple coupling in plenum
• Magnehelic¨ differential pressure gauge
• Unit painted Aircon gray with rust-inhibitive primer on both interior and exterior surfaces
• Fabricated grating in bottom of unit to facilitate bag removal
• 16 oz. singled polyester, copper wire grounded, bottom-removal bags with quick-release, stainless steel clamp bands
• Bottom-removal galvanized bag cages with aluminum venturies
• Hinged access door on side wall
• Two sets of installation & maintenance manuals
• 115 VAC, 60 Hz. single phase current required for sequence timer with adjustable on time (0.05 to 0.50 sec.) and off time (1.5 to 30 sec.)
• 230/460 VAC, 60 Hz. three phase current required for TEFC motor mounted on top of fan housing
• 90 to 100 PSIG clean, dry, uncontaminated compressed air supply required